Air & water Cooled Chillers

TT-13502

The TT-13502 is a two-circuit temperature control unit and water chiller combination unit with 2 x 6 kW heating capacity and 8 kW cooling capacity.

  • The unit has two independent water circuits with two sealless pumps and two stainless steel water tank of each 25 litres content. The 2 x 6 kW heating capacity is coupled with a 8 kW cooling capacity. For the cooling a chilled water connection is not required.
  • All components are made of corrosion resistant stainless steel or bronze.
  • Two self-optimizing microprocessor controllers with digital display of the set and actual value. Indication in 1/10°C range. Temperature display can be set to readout °C or °F.
  • Automatic or manual refill
  • Castors
Specifications

Temperature Control: Two microprocessor controllers MP-888 with digital display of the set
and actual value. Installed in the controller: 0-10 V or 4-20 mA command

Circuits: 2 independent circuits:
1 circuit for temperatures from 10°C until 90°C
1 circuit for temperatures from 10°C until 40°C

Pump capacity: 2 x max. 4,5 bar / max. 75 l/min

Heating capacity: 2 x 6 kW

Cooling capacity: 8 kW for both circuits installed cooling compressor, air cooled
air inlet located at the front, blow out located on the side / rear of the unit

Content water tank: 2 x 25 litres

Power consumption: approx. 15 kW

Connections:
TO-/FROM mould: 3/4” BS female thread (by both circuits)
Automatic water refill: 3/8” BS female thread

Dimensions: Length: 980 mm x Width: 660 mm x Height: 1’300 mm including castors

Noise level (at 3 m distance): 68 dBA

Weight: 220 kg empty

Colour: Silver grey RAL 7001

Safety Devices
  • Automatic level control with pre-warning at low water level.
  • Audible alarm to signal failure.
  • All failures are in addition visually shown
Enquire Now

Need help or advice on our products? Enquire Now

/Content/Images/news/Chemical.jpg

Latest News

Chemical

In 2018 Tool-Temp installed two TT430 Y units to a chemical company. These units were produced for the customer and are now listed as a machine in our product range. We flew the customer out to our head office in Switzerland to meet with the person in charge of the project, once they had all the requirements the machines went through to production. The units are equipped with three independent heat exchangers. The three-circuit cooling system makes it possible to work with oil below zero degrees. The installed self-optimizing temperature controller MP-988 works with three temperature probe inlets. The reference temperature for the regulation can be the temperature of the product inside the vessel or the oil temperature in the tank of the unit. To avoid any damage of the jacket, the pump pressure can be adjusted to the specifications of the vessel/reactor. The pump revolutions per minute can be adjusted very easily using the frequency inverter. As well as many other features.

Read Article More News